Mercedes-Benz CL-Class 2006 Owner's Manual page 511

Practical advice
Flat tyre
Turn crank 3 until the tyre is raised a
maximum of 3 cm from the ground.
P40.10.4637-31
1 Centring pin
Undo the uppermost wheel bolt com-
pletely.
In place of the wheel bolt, screw cen-
tring pin 1 from the vehicle tool kit
into the thread.
Undo the remaining wheel bolts.
!
Do not place wheel bolts in sand or on a dirty
surface. This could cause damage to the bolt and
wheel hub threads.
Remove the wheel.
490
Fitting a new wheel
G
Risk of accident
Replace damaged or corroded wheel bolts.
Never oil or grease wheel bolts.
G
Risk of accident
If a wheel hub thread is damaged, you must
not drive the vehicle any further. Consult a
qualified specialist workshop which has the
necessary specialist knowledge and tools to
carry out the work required. Mercedes-Benz
recommends that you use a Mercedes-Benz
Service Centre for this purpose. In particu-
lar, work relevant to safety or on safety-re-
lated systems must be carried out at a
qualified specialist workshop.
G
Risk of accident
Only use wheel bolts that have been de-
signed for the wheel and the vehicle. For
safety reasons, Mercedes-Benz recom-
mends that you only use wheel bolts which
have been specially approved for
Mercedes-Benz vehicles. Other bolts could
work loose.
Do not tighten the wheel bolts completely
while the vehicle is still jacked up. The vehi-
cle could topple off the jack.