Flat Tyre - Mercedes-Benz CL-Class 2006 Owner's Manual

Flat tyre

Your vehicle may be equipped with:
a TIREFIT kit
a "Minispare" emergency spare wheel*
a spare wheel*
the MOExtended run-flat system*
Preparing the vehicle
Stop your vehicle as far away as possi-
ble from moving traffic and on a firm,
non-slip and even surface.
Switch on the hazard warning lamps.
Move the transmission selector lever
to P.
Get all occupants out of the vehicle if
necessary, ensuring that they are not
endangered as they do so.
Switch off the engine and remove the
key from the ignition lock.
Vehicles with KEYLESS GO*:
Switch off the engine.
Open the driver's door.
The status of the on-board electronics
corresponds to key position 0.
Place the warning triangle
( page 400) or hazard warning lamps
at a suitable distance behind the vehi-
cle. Observe legal requirements.
Practical advice
G
Risk of injury
The jack is designed only to raise the vehicle
for a short while when a wheel is changed.
If you intend to work under the vehicle,
place the vehicle on stands.
Make sure that the jack is placed on a firm,
non-slip and level surface. Do not use wood-
en blocks or similar objects as a jack sup-
port plate, otherwise the jack may not be
able to achieve its load-bearing capacity if it
is not at its full height.
Do not start the engine at any time while the
wheel is being changed.
Do not lie under the vehicle when it is being
supported by the jack. If you do not raise the
vehicle as described, it could slip off the jack
(e.g. if the engine is started or a door or the
boot lid is opened or closed).
Flat tyre
483