Mercedes-Benz CL-Class 2006 Owner's Manual page 307

Controls
On-board computer
Checking the tyre pressures
You will find information about the tyre
pressure monitor in the "Checking the tyre
pressure electronically*" section
( page 384).
Restarting the tyre pressure loss warn-
ing system
You will find information in the "Tyre pres-
sure loss warning system" section
( page 383).
Calling up ASSYST PLUS
You will find information on ASSYST PLUS
in the "Service" section ( page 393).
Checking the engine oil level
You will find information about checking
the engine oil level using the on-board
computer in the "Engine oil" section
( page 377).
Settings menu
i
You will find a menu overview on
( page 275).
In the "Settings" menu, you can:
switch the daytime driving lights on or
off
286
switch the Intelligent Light System on
or off
set the limit speed for winter tyres
activate or deactivate the additional
speedometer
activate or deactivate the radar sensor
system*
Switching the daytime driving lights on
or off
If you have set "Daytime driving lamps" and
the light switch is at 0, the following light
up automatically while the engine is run-
ning:
Side lamps and dipped-beam head-
lamps
Licence plate lighting
Press ( or & to select the
"Settings" menu.
Press % or $ to select
"Daytime driving lights".
Press #.
Press # again if you wish to change
the current status.
The daytime driving lights are switched
on or off according to their previous
state.
i
If you turn the light switch to another posi-
tion apart from 0, the appropriate light switches
on.
i
Make sure that the light switch is at B or
* when you switch off the daytime driving
lights in darkness while the vehicle is in motion.
Switching the Intelligent Light System
on or off
You can use the "Intelligent Light System"
to set whether motorway mode, the Active
Light System, cornering light or the ex-
tended range foglamps are activated.
Press ( or & to select the
"Settings" menu.
Use % or $ to select the
"Intelligent Light System".
Press #.
Press # again if you wish to change
the current status.
The Intelligent Light System is activat-
ed or deactivated depending on its pre-
vious state.