Mercedes-Benz CL-Class 2006 Owner's Manual page 390

Opening or closing the garage door
Once programmed, the integrated remote
control will assume the function of the ga-
rage door system's remote control. Please
read the operating instructions for the ga-
rage door system.
Turn the key to position 2 in the ignition
lock.
Press the transmitter button on the in-
terior mirror which has been pro-
grammed to operate the garage door.
Garage door system with a fixed code:
indicator lamp 1 lights up permanent-
ly.
Garage door system with a rolling code:
indicator lamp 1 flashes for a brief pe-
riod and then lights up for approximate-
ly two seconds. This is repeated for up
to 20 seconds.
i
The transmitter will transmit a signal for as
long as the transmitter button is being pressed.
The transmission procedure is aborted after a
maximum of 20 seconds and indicator lamp 1
flashes. Press the transmitter button again if
necessary.
Clearing the remote control memory
Turn the key to position 2 in the ignition
lock.
Press and hold transmitter buttons 2
and 4 for about 20 seconds until indi-
cator lamp 1 flashes rapidly.
The memory is cleared.
i
You should clear the remote control memory
before selling the vehicle.
Floormats*
G
Risk of accident
Make sure that any floormats or carpets be-
ing used do not cause an obstruction and
are properly secured.
The floormats must always be correctly se-
cured using retainers and studs.
Before starting a journey, check that the
floormats are secure and reposition them if
necessary. An incorrectly secured floormat
could slip and thus impair correct operation
of the pedals.
Do not place several floormats on top of one
another.
i
To fit and remove the floormats more easily,
slide the respective seat back as far as possible.
Controls
Features
369