Mercedes-Benz CL-Class 2006 Owner's Manual page 178

Moving the map and selecting the des-
tination
To move the map: slide qmr,
wmx.
To adjust the map scale: turn ymz.
Turning clockwise enlarges the map,
turning anti-clockwise reduces the map
scale.
To select a destination: press n.
If the crosshair is located outside the
digital map, it is not possible to calcu-
late a route to this destination and you
will see the message "The destination is
located off the map".
Select "OK".
If the destination is within the limits
of the digital map, COMAND attempts
to assign the destination to the map,
which can take approximately 2 sec-
onds.
If the destination can be assigned, you
will see the address of the destination.
If not, you will see the display "Destina-
tion from map".
To start route calculation: select
"Start", see also ( page 154).
Entering an intermediate stop
i
When route guidance is active, you can en-
omp or ter an intermediate stop. Intermediate stops can
be predefined destinations from the following
predefined categories:
"Mercedes-Benz service"
"Hospital"
"Filling station"
"Car park"
"Restaurant"
However, you can also enter destinations other
than the predefined ones.
You can use the intermediate stop function to in-
fluence route guidance to the main destination.
When you have reached your intermediate stop,
COMAND automatically calculates the route to
the main destination.
Entering predefined destinations
Select "Navi"
over".
If an intermediate stop has already
been entered, you can change this.
COMAND navigation system* (entering a destination)
"Destination" "Stop-
COMAND
To change: select "Change stop-
over".
You can now select a category.
To select a category: select the cate-
gory, e.g. "Filling station".
COMAND first looks for destinations in
the immediate vicinity of the vehicle
and near to the vehicle's route. If there
are no destinations available there,
COMAND searches for destinations in
an area around the vehicle position.
If COMAND does not find any destina-
tions, you will see a message to this ef-
fect.
Select "OK".
You can now select a different cat-
egory.
If COMAND finds destinations, you will
see a list of the destinations and details
of how far away they are in the right-
hand side of the display. It can take a
few seconds for the information about
the distance to the destinations to be
displayed.
157