Measure:bwidth - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

20
:MEASure Commands

:MEASure:BWIDth

Command Syntax
:MEASure:BWIDth [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH | WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<r> ::= 1-2 in NR1 format
The :MEASure:BWIDth command installs a burst width measurement on
screen. If the optional source parameter is not specified, the current
measurement source is used.
This command is not available if the source is FFT (Fast Fourier Transform).
N O T E
Query Syntax
:MEASure:BWIDth? [<source>]
The :MEASure:BWIDth? query measures and returns the width of the burst
on the screen.
The burst width is calculated as follows:
Return Format
<value><NL>
<value> ::= burst width in seconds in NR3 format
See Also •
•
410
(see page 1138)
burst width = (last edge on screen - first edge on screen)
"Introduction to :MEASure Commands"
":MEASure:SOURce"
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 406
on page 444