0-5: Play Audio Cd - Korg TRITON Extreme Manual

0–5: Play Audio CD
You can use a CD-R/RW drive connected to the USB A con-
nector to play back an audio CD.
Connect the audio output of your CD-ROM/R/RW drive to
the TRITON Extreme's AUDIO INPUT 1, 2 jacks.
It is convenient to use this method to verify a CD that you
created in the Make Audio CD page.
If you're using a drive that does not have audio out-
put jacks or a headphone jack, you won't be able to
monitor the sound.
The audio CD will play back according to the Analog setting
for "Input (COMBI, PROG, SEQ, S.PLAY, MEDIA)."
It is not possible to play back an audio CD that has not
been finalized.
0–5a
0–5b
The audio CD can be controlled by the SEQUENCER keys.
SEQUENCER[START/STOP] key : Play/Stop
[FF>>] key
[<<REW] key
[PAUSE] key
[LOCATE] key
0–5a: Location, Media, Track, Index, Volume
Location
Displays the current location of the audio track that is play-
ing. When stopped, this specifies the location at which play-
back will begin.
When "Track" or "Index" are re-selected, this will be 00:00.0.
Media
Specifies the drive of the audio CD that will be played.
Only CD-ROM/R/RW drives can be selected.
Track
Selects the audio CD track that will be played.
Index
Specifies the index of the audio CD that will be played. This
is valid only if you have selected a track that has index data.
In the case of some CD-R/RW drives, index informa-
tion cannot be obtained.
Volume
Specifies the volume of the audio output from the CD-R/
RW drive.
Since some CD-R/RW drives do not support this, the
volume may not change when you adjust this setting.
0–5
: Fast-forward
: Rewind
: Pause
: Return to the beginning
of the track
(00:00.0...)
[01...]
[01...]
[0...127]
0–5b: Input
Input
Input1:
Input2:
Level
Pan
BUS (IFX/Indiv.) Select
[L/R, IFX1...5, 1, 2, 3(Tube), 4(Tube), 1/2, 3/4(Tube), Off]
Send1 (MFX1), Send2 (MFX2)
Here you can specify the input source, input level, pan, bus,
and master effect send for analog/digital audio devices.
Input settings are valid in Combination, Program,
Sequencer, Song Play, and Media modes. (☞Global P0:
0–3a)
Normally you will set these parameters as follows.
Input1 (L channel): "Level" 127, "Pan" L000, "BUS (IFX/
Indiv.) Select" L/R, "Send1"/"Send2"
000
Input2 (R channel): "Level" 127, "Pan" R127, "BUS (IFX/
Indiv.) Select" L/R, "Send1"/"Send2"
000
[Analog, S/P DIF]
[0...127]
[L000...C064...R127]
[000...127]
197