Examples Of Ipv6 Radius Application - Planet WGSW-52040 Configuration Manual

Switch(config)#radius-server key test
Switch(config)#aaa enable
Switch(config)#aaa-accounting enable
Switch(config)#dot1x enable
Switch(config)#interface ethernet 1/2
Switch(Config-Ethernet1/2)#dot1x enable
Switch(Config-Ethernet1/2)#dot1x port-control auto
Switch(Config-Ethernet1/2)#exit

42.3.3 Examples of IPv6 Radius Application

Connect the computer to the interface 1/2 of the switch, and enable IEEE802.1x on
interface1/2. Use MAC based authentication. Configure the IP address of the switch as
2004:1:2:3::2, and connect the switch with any interface except interface 1/2 to the RADIUS
authentication server. Configure the IP address of the RADIUS server to be 2004:1:2:3::3. Use
the default ports 1812 and 1813 for authentication and accounting respectively. Install the
IEEE802.1x authentication client software on the computer, and use the client for IEEE802.1x
authentication.
The detailed configurations are listed as below:
Switch(config)#interface vlan 1
Switch(Config-if-vlan1)#ipv6 address 2004:1:2:3::2/64
Switch(Config-if-vlan1)#exit
2004:1:2:3::2
2004:1:2:3::1 Radius Server
Figure 42-17: IPv6 Radius
42-156
2004:1:2:3::3