Table of Contents
Advertisement
4.3.4 VLAN Translation
4.3.4.1 VLAN to Group Configuration
This page allows you to configure switch Ports to use a given VLAN Translation Mapping Group. This will enable all VLAN
Translation mappings of that group (if any) on the selected switch port.
The displayed settings are:
Object
Port
Default
Group ID
Buttons
Auto-refresh
: Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
: Click to refresh the page immediately.
:
Click to undo any changes made locally and revert to previously saved values.
: Click to apply changes.
Figure 4-3-31: VLAN Translation Port Configuration
Description
The Port column shows the list of ports for which you can configure the VLAN
Translation Mapping Group.
To set the switch port to use the default VLAN Translation Group click the
checkbox and press Save.
The VLAN Translation mappings are organized into Groups, identified by the
Group ID. This way a port is configured to use a number of VLAN Translation
mappings easily by simply configuring it to use a given group. Then number of
possible groups in a switch is equal to the number of ports present in this switch.
A port can be configured to use any of the groups, but only one at any given
time. Multiple ports can be configured to use the same group. A valid Group ID is
an integer value from 1 to 10.
Note: By default, each port is set to use the group with Group ID equal to the
port number. For example, port #1 is by default set to use group with GID = 1.
151
User's Manual of WGS-5225-8P2S Series
Advertisement
Table of Contents
