Download Ssl Privkey - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

download ssl privkey

download ssl <ip_address> privkey <key file>
Description
Permits downloading of a private key from files stored in a TFTP server.
Syntax Description
ip_address
key file
Default
N/A.
Usage Guidelines
If the operation is successful, the existing private key is overwritten.
After a successful download, a check is performed to find out whether the private key downloaded
matches the public key stored in the certificate. If the private and public keys do not match, the switch
displays a warning similar to the following:
Public Key in the certificate
corresponding certificate.
The certificate and private key file should be in PEM format and generated using RSA as the
cryptography algorithm.
Downloaded certificates and keys are not saved across switch reboots unless you save your current
switch configuration. Once you issue the
configuration file and the private key is stored in the EEPROM.
Similar to SSH2, before you can use any SSL commands, you must first download and install the
separate Extreme Networks SSH software module (ssh.xmod). This additional module allows you to
configure both SSH2 and SSL on the switch. SSL is packaged with the SSH module; therefore, if you do
not install the module, you are unable to configure SSL. If you try to execute SSL commands without
installing the module first, the switch notifies you to download and install the module. To install the
module, see the instructions in
XOS Concepts Guide.
Remote IP Address Character Restrictions. This section provides information about the characters
supported by the switch for remote IP addresses.
When specifying a remote IP address, the switch permits only the following characters:
Alphabetical letters, upper case and lower case (A-Z, a-z)
●
Numerals (0-9)
●
ExtremeWare XOS 11.5 Command Reference Guide
Specifies the IP address of the TFTP server.
Specifies the name of the private key file.
Warning: The Private Key does not match with the
. This warning acts as a reminder to also download the
command, the downloaded certificate is stored in the
save
Appendix A, "Software Upgrade and Boot Options,"
download ssl privkey
of the ExtremeWare
1001