Enable Web Https - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Security Commands

enable web https

enable web https
Description
Enables secure socket layer (SSL) access to the switch on the default port (443).
Syntax Description
This command has no arguments or variables.
Default
Disabled.
Usage Guidelines
Use this command to allow users to connect using a more secure connection.
Similar to SSH2, before you can use any SSL commands, you must first download and install the
separate Extreme Networks SSH software module (ssh.xmod). This additional module allows you to
configure both SSH2 and SSL on the switch. SSL is packaged with the SSH module; therefore, if you do
not install the module, you are unable to configure SSL. If you try to execute SSL commands without
installing the module first, the switch notifies you to download and install the module. To install the
module, see the instructions in Appendix A, "Software Upgrade and Boot Options," of the ExtremeWare
XOS Concepts Guide.
To use secure HTTP access (HTTPS) for web-based login connections, you must specify HTTPS as the
protocol when configuring the redirect URL. For more information about configuring the redirect URL,
see the command.
configure netlogin redirect-page
Prior to ExtremeWare XOS 11.2, the SSH module did not include SSL. To use SSL, you must download
and install the current SSH module.
If you are currently running SSH with ExtremeWare XOS 11.0 or 11.1, and you want to use SSL for
secure HTTPS web-based login, you must upgrade your core software image to ExtremeWare XOS 11.2
or later, install the SSH module that works in concert with that core software image, and reboot the
switch.
Example
The following command enables SSL on the default port:
enable web https
History
This command was first available in the ExtremeWare XOS 11.2 and supported with the SSH module.
1016
ExtremeWare XOS 11.5 Command Reference Guide