Show Ssl - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

show ssl

show ssl
Description
Displays the secure socket layer (SSL) configuration.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
This command displays the following information:
HTTPS port configured. This is the port on which the clients will connect.
●
Length of the RSA key (the number of bits used to generate the private key).
●
Basic information about the stored certificate.
●
Similar to SSH2, before you can use any SSL commands, you must first download and install the
separate Extreme Networks SSH software module (ssh.xmod). This additional module allows you to
configure both SSH2 and SSL on the switch. SSL is packaged with the SSH module; therefore, if you do
not install the module, you are unable to configure SSL. If you try to execute SSL commands without
installing the module first, the switch notifies you to download and install the module. To install the
module, see the instructions in
XOS Concepts Guide.
If you attempt to use this command before installing the SSH module, the switch displays a message
similar to the following:
SSL Module: Not Installed.
NOTE
The switch utilizes the SSH module for SSL functionality. You do not install an SSL module, only the SSH module.
Example
The following command displays the SSL configuration:
show ssl
ExtremeWare XOS 11.5 Command Reference Guide
Appendix A, "Software Upgrade and Boot Options,"
show ssl
of the ExtremeWare
1029