Switch Renumber - Dell PowerConnect 8024 Cli Reference Manual

unit — The switch identifier. (Range: 1–12)
•
value — The priority of one backup switch over another. (Range: 0–12)
•
Default Configuration
The switch priority defaults to the hardware management preference value of 1.
Command Mode
Global Configuration mode
User Guidelines
Switches that do not have the hardware capability to become the Management Switch are not
eligible for management.
Once the priority of a switch has been configured, it cannot be reset to the default. Switch
priority is not affected by the "clear config" command.
Example
The following example displays how to configure switch number "1" to have a priority of "2" for
becoming the Management Switch.
console(config)#switch 1 priority 2

switch renumber

Use the switch renumber command in Global Configuration mode to change the identifier for a
switch in the stack. Upon execution, the switch is configured with the configuration
information for the new switch, if any is available. The old switch configuration information is
retained; however, the old switch will be
Syntax
oldunit
switch
oldunit — The current switch identifier. (Range: 1–12)
•
newunit — The updated value of the switch identifier. (Range: 1–12)
•
Command Mode
Global Configuration mode
User Guidelines
This command is executed on the Management Switch.
1106
System Management Commands
newunit
renumber
operationally unplugged
.