Table 145: Sample Radius Access-Accept Packet; Using Tags With Radius Attributes - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

JUNOSe 11.1.x Broadband Access Configuration Guide
NOTE: Service Manager statistics collection is a three-part procedure. You must
configure statistics information in the service definition macro file, enable statistics
collection in the RADIUS record, and also enable statistics collection for the policy
referenced in the service macro using the statistics enabled keyword in the command
used for policy attachment in the profile.
The Service-Volume and Service-Timeout VSAs rely on the values captured by the
Service Manager statistics feature to determine when a threshold is exceeded.
Therefore, you must configure and enable statistics collection to use these attributes.
Service-Volume For detailed information about Service Manager statistics see
"Configuring Service Manager Statistics" on page 686.
Table 145 on page 664 describes a partial RADIUS Access-Accept packet that activates
a service session for subscriber client1@isp1.com. (Figure 29 on page 648 shows the
service definition macro file that creates the tiered service.) The session enables the
subscriber to use the tiered service with an input bandwidth of 1280000 and output
bandwidth of 5120000. The subscriber can use the service for 5 hours (18000
seconds), and Service Manager captures both timestamp and volume statistics during
the session (service-statistics value of 2). Also, accounting for the service is updated
every 600 seconds (10 minutes).

Table 145: Sample RADIUS Access-Accept Packet

Using Tags with RADIUS Attributes

Service Manager uses tagged RADIUS VSAs to enable a single RADIUS record to
activate multiple service sessions for a subscriber, with each session having unique
attributes. A particular tag identifies a specific Activate-Service attribute and all other
RADIUS attributes that are associated with that Activate-Service attribute.
You can specify a maximum of 8 tags (1–8), which enables you to activate up to
eight unique service sessions for a subscriber in a single RADIUS record. The following
are tagged VSAs they must always have a tag in their RADIUS entry:
664
Using RADIUS to Manage Subscriber Service Sessions
RADIUS Attribute
username
class
service-activation
service-timeout
service-statistics
service-interim-acct-interval
Activate-Service
Service-Statistics
Tag Value
none client1@isp1.com
none (binary data)
6 tiered(1280000, 5120000)
6 18000
6 2
6 600