Service Manager Platform Considerations; Service Manager References; Service Manager Configuration Tasks - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Table 138: Service Manager Terms and Acronyms (continued)

Service Manager Platform Considerations

Service Manager is supported on all E Series routers. For information about the
modules supported on E Series routers:

Service Manager References

For more information about the topics covered in this chapter, see the following
documents:

Service Manager Configuration Tasks

To use the Service Manager application to create subscriber service sessions, you
perform the following tasks:
Term
Service instance
Service session
Service session profile
See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx
models, and the ERX310 Broadband Services Router.
See the E120 and E320 Module Guide for modules supported on the E120 and
E320 Broadband Services Routers.
Data-Over-Cable Service Interface Specifications (DOCSIS) 2.0 Radio Frequency
Interface Specification CM-SP-RFIv2.0-I10-051209.
For information about using the JUNOSe software's macro language, see the
Writing CLI Macros chapter in JUNOSe System Basics Configuration Guide.
For information about setting up policy-based routing features for Service
Manager, such as rate-limit profiles, classifier control lists, policy lists, and
hierarchical and merged policies, see the JUNOSe Policy Management Configuration
Guide.
For information about creating QoS profiles and QoS parameters, see the JUNOSe
Quality of Service Configuration Guide.
For information about creating IPv4 interface profiles, see the Configuring IP
chapter in JUNOSe IP, IPv6, and IGP Configuration Guide.
Create and manage service definitions
Chapter 27: Configuring Service Manager
Definition
An instance that is created when you specify parameter values
for a service definition to create a service session
A session that is created when a service instance is activated for
a subscriber; a subscriber can have multiple active service
sessions
A provider-configured profile that applies optional attributes to
a service session; CLI only
Service Manager Platform Considerations
637