Figure 22: Subscriber Interfaces Using A Destination Address To Demultiplex - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

JUNOSe 11.1.x Broadband Access Configuration Guide
Using a Destination Address to Demultiplex Traffic
The example in Figure 22 on page 616 shows how you can use static subscriber
interfaces to direct traffic toward special local content on the network, based on the
traffic's destination address. In this application, a local VoIP service is on network
10.11.0.0./16, and a local gaming service is on network 10.12.0.0/16.
Figure 22: Subscriber Interfaces Using a Destination Address to Demultiplex Traffic
To configure the static subscriber interfaces shown in Figure 22 on page 616, perform
the following steps:
1.
616
Configuring Static Subscriber Interfaces
Configure a primary IP interface on a supported layer 2 interface.
a. Create a layer 2 interface.
host1(config)#interface fastEthernet 3/1
b. Create a primary IP interface.
host1(config-if)#ip address 10.1.1.1 255.0.0.0