Table 72: Tunnel--Tx-Speed-Method Radius Attribute; Ppp Accounting Statistics - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide

Table 72: Tunnel--Tx-Speed-Method RADIUS Attribute

Attribute
Number Attribute Name
[26-94] Tunnel-Tx-Speed-Method
Related Topics

PPP Accounting Statistics

JUNOSe accounting for tunneled subscribers at the L2TP LAC counts the payload that
PPP passes to or receives from L2TP for transport. At this stage in the protocol
processing, any padding outside PPP, such as that for PPPoE, has been removed.
Accounting includes the authentication acknowledgement packet, CHAP success
packets, and PAP acknowledgment packets. Accounting ends when L2TP has been
notified to terminate the session. The statistics are reported in the following RADIUS
attributes:
402
PPP Accounting Statistics
Description
The method that the router
uses to calculate the transmit
connect speed of the
subscriber's access interface
Transmit Connect Speed Calculation Methods on page 395
Using AAA Domain Maps to Configure the Transmit Connect Speed Calculation
Method on page 398
Using AAA Tunnel Groups to Configure the Transmit Connect Speed Calculation
Method on page 399
Using AAA Default Tunnel Parameters to Configure the Transmit Connect Speed
Calculation Method on page 400
Using RADIUS to Configure the Transmit Connect Speed Calculation Method on
page 401
aaa tunnel tx-connect-speed-method
tx-connect-speed-method
Attribute Number
42
43
Subtype
Length Length Value
12 6 integer:
Attribute Name
Acct-Input-Octets
Acct-Output-Octets
1 = static-layer2; TX speed
based on static layer 2
settings
2 =dynamic-layer2; TX speed
based on dynamic layer 2
settings
3 = qos; TX speed based on
QoS settings
4 = actual; TX speed that is
the lesser of the
dynamic-layer2 value or the
qos value