Recommended Tools - Oracle EAGLE Installation Manual

Metallization (30 or 50µ in. Au over 50µ in. Ni), at the connector interface. The wire
required follows: Category 5E SCTP 26AWG 7/34 tinned copper 4 PR per IEC 11801,
TIA/EIA 568B, EN 50173 with Overall shield, 26 AWG stranded T.C. drain wire, UL
CMR, C(UL) CMR rating, or other agency listing.
Signaling Cables (for example, T1, ATM) are EAGLE proprietary and must be
purchased from Oracle.

6.1.3.2 Recommended Tools

Oracle tools should be labeled "Property of ORACLE" with either a press-on Field Tool
Identification label or Field Tool Identification wrap.
• Safety glasses
• Diagonal cutters
• Coax crimping tool
• Tie-wrap tool
• Flush cutters
• Slotted screwdriver with 1/8-inch blade with 8-inch shank
• Multimeter
LAN Ethernet Cable Installation
Run each 10BASE-2 Thin net coax cable or 10BASE-T twisted pair cable from the
1.
Ethernet network onto the cable rack.
Run each cable down the respective side of the system, outside the cable tie bars,
2.
and around the top or bottom edge of the terminating shelf.
The ACM location number in
slot (right two digits) that contain the ACM. For example, an ACM location of 1108
indicates slot 08 of the Control Shelf (shelf 11). For ACMs located in an
Extension Shelf, replace "XX" in the ACM location number with the number for
that shelf (12, 13, 21, 22, 23, 31, 32, or 33).
Table 6-1
Shelf
Note:
Use Table 6-1 to locate the ACM backplane interface connector for each
Ethernet connection.
Table 6-1
ACM Card and Backplane Interface
Control Shelf
Intra-system Cable Installation
consists of the shelf (left two digits) and the
Backplane (P/
ACM Location N 850-0330-03/04/06)
Connector
1101
1102
1103
1104
Chapter 6
J45
J44
J43
J42
6-12