Table of Contents
Advertisement
Table 6-1
(Cont.) ACM Card and Backplane Interface
Shelf
Extension Shelves (XX is shelf
location)
Attach a BNC connector to the end of the 10BASE-2 coax cable.
3.
If necessary, attach an RJ45 type connector to the end of the 10BASE-T twisted pair
cable.
Secure each cable, see
4.
as follows:
Plug the 26-pin side of the adapter into the backplane interface connector.
a.
Start one of the adapter connector screws, and then alternately tighten the two
b.
adapter screws.
Ensure the adapter slide latch is in the unlocked (up) position see to
c.
Plug the single port MAU into the adapter.
d.
Move the adapter slide latch to the locked (down) position.
e.
ACM Location
1105
1106
1107
1108
1111
1112
XX01
XX02
XX03
XX04
XX05
XX06
XX07
XX08
XX11
XX12
XX13
XX14
XX15
XX16
XX17
XX18
Figure 6-7
to its respective connector on the system backplane
Chapter 6
Intra-system Cable Installation
Backplane (P/
N 850-0330-03/04/06)
Connector
J41
J40
J39
J38
J37
J36
Backplane (P/
N 850-0356-03)
Connector
J24
J23
J22
J21
J20
J19
J18
J17
J16
J15
J14
J13
J12
J11
J10
J9
Figure
6-6.
6-13
Advertisement
Table of Contents
