Table of Contents
Advertisement
The following is sample output.
rlghncxa03w 01-03-02 13:05:05 EST Rel 28.1.0
FLASH Memory Downloading for card 1105 Started.
rlghncxa03w 01-03-02 13:05:05 EST Rel 28.1.0
BPDCM Downloading for card 1105 Complete.
rlghncxa03w 01-03-02 13:05:05 EST Rel 28.1.0
Command Completed.
;
Enter the following command to activate the FLASHGPL on the card:
19.
act-flash:loc=xxxx
Where xxxx is the location of the card.
The following is sample output:
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 31.3.0
FLASH Memory Activation for card 1105 Started.
;
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 31.3.0
FLASH Memory Activation for card 1105 Completed.
;
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 31.3.0
Command Completed.
;
Enter the following command to return the upgraded MCPM card into service.
20.
This causes the MASP to begin downloading tables to the new MCPM card.
alw-card:loc=xxxx
Where xxxx is the MCPM card location.
When the card has been successfully loaded (there will be a response on the terminal
that downloading is complete). This can take up to 10 minutes.
Note:
Ensure that the primary FTP server points to the primary card.
Enter the following command on the primary card to return the card to the status
21.
recorded in
1
prior to the upgrade:
init-card:loc=xxxx
where xxxx is the location of the primary card.
Enter the following command to verify the card is operational (IS-NR).
22.
rept-stat-meas
Chapter 6
User Upgrade Procedures
6-29
Advertisement
Table of Contents
