Table of Contents
Advertisement
Record any troubles and ensure that no clock problems exist.
Note:
If clock errors exist that cannot be resolved, contact the
Support (MOS)
Generate a clock status report to ensure that the current primary and secondary
2.
composite clock sources are running and determine which MASP is active or on
standby; enter:
rept-stat-clk
The output displays the card status and the presence of the primary and
secondary clocks, the number of cards that use clocks A and B, and the number of
cards using bad clocks.
tekelecstp 00-12-10 11:35:15 EST Rel 26.0.0
CARD LOC = 1114 (Active )
PRIMARY BITS
= Active
SECONDARY BITS
= Idle
PSTSSTAST
SYSTEM CLOCKIS-NRActive-----
# Cards using CLK A = 11
# Cards using CLK B = 3
# Cards using CLK I = 0
PSTSSTAST
Command Completed.
where:
•
CARD LOC is the TDM card location and the status of the MASP ·
•
PRIMARY BITS is the status of the primary composite clock
–
Idle indicates that the present clock source is valid but not selected as
active clock source
–
Active indicates that the present clock source is valid and selected as
active clock source
–
Fault indicates that no clock source is present ·
•
SECONDARY BITS is the status of the secondary composite clock
–
Idle indicates that the present clock source is valid but not selected as
active clock source
–
Active indicates that the present clock source is valid and selected as
active clock source
–
Fault indicates that no clock source is present ·
•
# Cards using CLK A, B, I is the number of cards using clocks A, B,
and I.
•
# Cards using CLK A, B is the number of cards using clock A or clock B,
when clock A or B is bad. NOTE: If any card indicates a bad clock,
for assistance before starting the cable replacement.
CARD LOC
= 1116 (Standby)
PRIMARY BITS
SECONDARY BITS
# Cards with bad CLK A = 0
# Cards with bad CLK B = 0
Chapter 6
Source Timing
My Oracle
= Active
= Idle
6-72
Advertisement
Table of Contents
