Oracle EAGLE Installation Manual page 141

Table of Contents

Advertisement

FLASH Memory Activation for card 1105 Completed.
;
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 31.3.0
Command Completed.
;
Enter the following command to return the upgraded MCPM card into service.
14.
This causes the MASP to begin downloading tables to the new MCPM card
.alw-card:loc=xxxx
Where xxxx is the MCPM card location.
When the card has been successfully loaded (there will be a response on the
terminal that downloading is complete). This can take up to 10 minutes.
Enter the following command to verify the card is operational (IS-NR).
15.
rept-stat-measIf the secondary MCPM card is operational, go to 16. If it is not,
call the
My Oracle Support
Enter the following command to remove the primary MCPM card from service.
16.
Do not use the force command unless this is the only MCPM card in service;
MCPM collection and reporting service should be maintained at all times.
Note:
Removing the last MCPM or only MCPM from service will cause loss of
measurements data.
If there is more than one MCPM card in service, enter:
inh-card:loc=xxxx
where xxxx is the primary MCPM card location.
If there is only one MCPM card in service, enter:
inh-card:loc=xxx:force=yes
where xxxx is the primary MCPM card location.
Remove the MCPM card.
17.
See
Removing a Card in an Existing EAGLE System
Place the removed MCPM card into an ESD container; do not put it into the spare
card storage shelf. Place the new MCPM (EDSM) card into its place. Be sure the
revision numbers of the cards are compatible with the EAGLE software release. If
they are not compatible, you should go to
release level of the EAGLE system. If your card is compatible with the EAGLE
software release level, proceed to 20. If in doubt about the compatibility of your
new hardware, call the
Enter the following command to flash the card:
18.
init-flash:loc=xxxx:code=appr
Where xxxx is the location of the card.
(MOS).
18
to flash the card to the software
My Oracle Support
(MOS).
Chapter 6
User Upgrade Procedures
for removal procedures.
6-28

Advertisement

Table of Contents
loading

Table of Contents