Figure 5-19
5.3.4 Logic Ground Connections to the System Ground Bar
Note:
It is a requirement that when mating dissimilar metals non oxidizing grease is used
between them as a corrosion inhibitor.
Place a clear heat-shrink on the cable.
1.
Butt, strip the end of the cable, and apply a small amount of non oxidizing grease to the
2.
conductor.
Note:
The size of the cable is determined by the overall length of the cable run. Refer
to the Site File Book.
Clamp Reading on System Frame and Logic
Frame Ground and Logic Ground Cabling Procedures
Chapter 5
5-21