Table of Contents
Advertisement
Repeat
13.
This procedure is complete.
6.4.4 Installing Fan Assembly 890-1038-01 or 890-1038-02
Tools needed:
•
#1 Flat screwdriver
•
#2 Philips screwdriver (long)
•
Fiber Paper (Approximately 2' x 3')
•
Tie Wraps
Determine where the fan assembly will be installed and be aware of hardware that needs
1.
to be retained or installed in a specific way, see
Place a piece of fiber paper on the top of the shelf below where the fan is to be installed,
2.
to ensure that nothing will drop into the area and equipment below.
a.
b.
c.
Remove the four screws, two on each side, from the mounting brackets on the frame that
3.
hold the baffle in place, on both sides.
This will allow the removal of the baffle.
Figure 6-24
Place the screws in a safe place because they are used later in this procedure.
4.
Remove the baffle through the front of the frame.
5.
Remove the fan unit from the container and remove the grill and filter from the unit
6.
assembly.
The fan is shipped with the side flange not attached. Set the grill and filter in a safe
location; it will be used later in this procedure.
7
through
12
for each fan unit installed.
The fan unit is secured with the same screws that are removed from the frame
holding the baffle in place.
The brackets are installed from the rear of the frame using the screws provided with
the brackets (standard frame).
When the brackets are attached, secure them to the frame using external tooth
washers and four screws.
System Air Baffle
Fan Assembly Installation and Cabling
Figure
6-25.
Chapter 6
6-45
Advertisement
Table of Contents
