Table of Contents
Advertisement
Note:
The clocking and fan control signals used to support frame 6 and frame 7 are
eliminated in the 850-0330-06 or -07 version and later of the Control Shelf
Backplane because those frames are no longer supported in the EAGLE STP
system.
Figure 6-4
6.1.2 Interface Cable Installation
The procedure in this section is used to install the interface cables. The interface cables, one
per signaling link, contain solid conductor twisted pairs for both directions of transmission in a
single shield. They have connectors at one end for connection to the system backplanes.
Control Shelf Cabling
Chapter 6
Intra-system Cable Installation
6-5
Advertisement
Table of Contents
