Oracle EAGLE Installation Manual page 136

Note:
Removing the last MCPM or only MCPM from service will cause loss of
measurements data.
Remove the MCPM card.
19.
See Removing a Card in an Existing EAGLE System
Place the removed MCPM card into an ESD container.
a.
Note:
Do not put it into the spare card storage shelf.
Place the new MCPM (E5-MCPM-B) card into its place.
b.
Be sure the revision numbers of the card is compatible with the EAGLE software
c.
release.
• If they are not, go to
EAGLE system.
• If your card is compatible with the EAGLE software release level, go to 22.
• If in doubt about the compatibility of your new hardware, call the
Support (MOS).
Enter the following command to flash the card:
20.
init-flash:loc=xxxx:code=appr
where xxxx is the location of the card.
The following is sample output.
rlghncxa03w 01-03-02 13:05:05 EST Rel 44.0
FLASH Memory Downloading for card 1105 Started.
rlghncxa03w 01-03-02 13:05:05 EST Rel 44.0
BLMCAP Downloading for card 1105 Complete.
rlghncxa03w 01-03-02 13:05:05 EST Rel 44.0
Command Completed.
;
Enter the following command to activate the FLASHGPL on the card:
21.
act-flash:loc=xxxx
where xxxx is the location of the card.
The following is sample output:
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 44.0
FLASH Memory Activation for card 1105 Started.
;
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 44.0
FLASH Memory Activation for card 1105 Completed.
;
for removal procedures.
20 to flash the card to the software release level of the
Chapter 6
User Upgrade Procedures
My Oracle
6-23