Table of Contents
Advertisement
angle side is up and slants away from the frame in the container. Place the ramp
against the front edge of the shipping container. Insert the U-bolts in the holes to
secure the ramp support and container together.
Open the rear door of the shipping container
5.
Figure 4-2
Shipping Container for Heavy Duty Frame
Use the 9/16 inch wrench to unbolt the wooden retaining bar across the front of
6.
the frame. Do not discard the retaining brace or the bolts. At this time Do not
remove the bolts holding the dolly to the frame. Refer to
At least two people are required any time a frame is moved. Use the 9/16 inch
7.
wrench to turn the threaded rod counter clockwise to lower the wheels of the dolly
and to raise the frame and dolly enough to clear the front edge of the shipping
container, approximately 1-1/2 inches. The threaded bolts must be turned at the
Chapter 4
Unpacking
Figure
4-3.
4-2
Advertisement
Table of Contents
