Oracle EAGLE Installation Manual page 134

rept-stat-meas
• If the secondary MCPM card is operational, go to 9.
• If it is not, call the
If you want to upgrade a spare MCPM, go to 10.
9.
Otherwise, got to 18.
Remove the spare MCPM card from the spare card storage shelf.
10.
Place it into an ESD container.
11.
Enter the following command to remove the previously upgraded secondary MCPM card
12.
from service.
• If there is more than one MCPM card in service, enter:
inh-card:loc=xxxx
• If there is only one MCPM card in service, enter:
inh-card:loc=xxx:force=yes
where xxxx is the secondary MCPM card location.
This card will become the spare.
Do not use the force command unless this is the only MCPM card in service; MCPM
collection and reporting service should be maintained at all times.
Note:
Removing the last MCPM or only MCPM from service will cause loss of
measurements data.
Remove the MCPM card.
13.
See Removing a Card in an Existing EAGLE System
Place the removed MCPM card into the spare card storage shelf.
a.
Place the new MCPM (E5-MCPM-B) card into its place.
b.
Be sure the revision numbers of the card is compatible with the EAGLE software
c.
release.
• If they are not, go to
EAGLE system.
• If your card is compatible with the EAGLE software release level, go to 16.
• If in doubt about the compatibility of your new hardware, call the
Support (MOS).
Enter the following command to flash the card:
14.
init-flash:loc=xxxx:code=appr
where xxxx is the location of the card.
The following is sample output.
rlghncxa03w 01-03-02 13:05:05 EST Rel 44.0
FLASH Memory Downloading for card 1105 Started.
My Oracle Support (MOS).
14 to flash the card to the software release level of the
User Upgrade Procedures
for removal procedures.
My Oracle
Chapter 6
6-21