Table of Contents
Advertisement
Figure 4-17
4.6 Rear Covers
Gray tinted plastic rear covers with round holes are provided, three per frame, to
physically protect the system backplanes and cables, see
Carefully peel off the protective wrapper from each cover.
1.
With the round holes up, place the cover into the support groove.
2.
Line up the rear cover holes with the holes in the frame support arm.
3.
Secure rear cover in place with two screws.
4.
Unit Separation Bracket Installation
Chapter 4
Rear Covers
Figure
4-18.
4-20
Advertisement
Table of Contents
