Oracle EAGLE Installation Manual page 140

command unless this is the only MCPM card in service; MCPM collection and reporting
service should be maintained at all times.
Note:
Removing the last MCPM or only MCPM from service will cause loss of
measurements data.
If there is more than one MCPM card in service, enter:
inh-card:loc=xxxx
where xxxx is the secondary MCPM card location.
If there is only one MCPM card in service, enter:
inh-card:loc=xxx:force=yes
where xxxx is the secondary MCPM card location.
Remove the MCPM card.
11.
See Removing a Card in an Existing EAGLE System
removed MCPM card into the spare card storage shelf. Place the new MCPM (EDSM)
card into its place. Be sure the revision numbers of the card is compatible with the
EAGLE software release. If they are not, go to
release level of the EAGLE system. If your card is compatible with the EAGLE software
release level, go to 14
My Oracle Support (MOS).
Enter the following command to flash the card:
12.
init-flash:loc=xxxx:code=appr
Where xxxx is the location of the card.
The following is sample output.
rlghncxa03w 01-03-02 13:05:05 EST Rel 28.1.0
FLASH Memory Downloading for card 1105 Started.
rlghncxa03w 01-03-02 13:05:05 EST Rel 28.1.0
BPDCM Downloading for card 1105 Complete.
rlghncxa03w 01-03-02 13:05:05 EST Rel 28.1.0
Command Completed.
;
Enter the following command to activate the FLASHGPL on the card:
13.
act-flash:loc=xxxx
Where xxxx is the location of the card.
The following is sample output:
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 31.3.0
FLASH Memory Activation for card 1105 Started.
;
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 31.3.0
12
. If in doubt about the compatibility of your new hardware, call the
User Upgrade Procedures
for removal procedures. Place the
to flash the card to the software
Chapter 6
6-27