Table of Contents
Advertisement
Figure 6-11
Push Inject/Eject Clamps Outward
Place the card you have removed in an electrostatic discharge (ESD) protective
3.
container, or place the card in the spare card storage shelf.
Be sure that the replacement card has the same part number and revision number as the
4.
card you have just removed (unless this is an upgrade).
Open the ejector levers on the replacement card.
5.
Carefully align the card's edges with the top and bottom card guides. Then push the card
along the length of the card guides until the rear connectors on the card engage the
mating connectors on the target shelf backplane.
Press the front of the card's faceplate using constant pressure until you feel the card's
6.
progress cease.
attention:
Do not impact the faceplate in order to mate the connectors. Any impact to the
card's faceplate can damage the faceplate, the pins, or the connectors.
Push in the top and bottom inject/eject clamps.
7.
This locks the card in place and ensures a strong connection with the pins on the target
shelf backplane.
Chapter 6
User Upgrade Procedures
6-31
Advertisement
Table of Contents
