Removing A Card In An Existing Eagle System - Oracle EAGLE Installation Manual

6.3.3 Removing a Card in an Existing EAGLE System

Use this procedure anytime a card is removed from a previously operational EAGLE
system for upgrade purposes. See Maintenance Guide for card replacement. Failure
to use this procedure may result in equipment damage. Use the procedures at the
beginning of this section before physically removing any cards.
attention:
Before performing any maintenance procedures on the EAGLE, make sure
you wear a wrist strap connected to the wrist strap grounding point of the
EAGLE System.
Before removing, reseating, or initializing a card, inhibit any OAP terminal ports that
are in-service normal (IS-NR) to ensure the card loads properly. No database updates
or single command line entries should be made while the card is loading.
attention:
This procedure may interrupt service. When possible, perform maintenance
during low traffic and database provisioning periods, such as the
maintenance window.
Locate the card to be removed.
1.
Push the inject/eject clamps outward from the card's faceplate (top clamp in the
2.
"UP" position, bottom clamp in the "DOWN" position). Pull the levers away from
the shelf until they are parallel to the floor.
Gently pull the card towards you until the card clears the shelf.
Note:
To ensure no loss of service, be sure to check that the green LED on the
card is not lit when you remove the card.
Chapter 6
User Upgrade Procedures
6-30