Table of Contents
Advertisement
To cable the fan assembly, plug a cable onto the shelf on backplane FAN A
1.
POWER, and connector J9.
Tighten the screws on the connector.
When the cable is connected to the backplane route the cable to the top tie-down
2.
rod and secure the cable with a tie-wrap.
Route the cable to the right side of the frame.
3.
Run the cable between the shelf and the traverse arms.
Secure the fan cables to the back side of the traverse arm using tie-wraps.
4.
Plug the other end of the cable onto the fan unit connector marked FAN A
5.
POWER.
Tighten the screws on the connector.
The other fan cable (P/N 830-0690-01) plugs into the backplane connector J8.
6.
Tighten the screws on the connector.
Route the cable out to the top tie down rod and secure it using a tie-wrap.
7.
Run the cable down between the shelf and traverse arm.
Secure the cables to the back side of the traverse arms using tie-wraps.
8.
Plug the other end of the cable onto the fan unit connector marked FAN B
9.
POWER.
Secure the connector.
6.4.3 Powering Up the Fan Assembly
All fans are fused at 3A (blue) per feed.
warning:
Before powering up the fans, ensure that the shelf above the fan does not
contain any empty slots. Install the air management card in any empty slots.
See
guidelines.
Procedure — Power up Fan Assembly
After the fan is installed, the powering up process depends on the shelf location.
1.
Caution:
Do not form the cable with the LIM cables.
Caution:
Do not form FAN POWER cables with LIM cables.
Card Installation and Replacement
Fan Assembly Installation and Cabling
for general card installation
Chapter 6
6-42
Advertisement
Table of Contents
