Oracle EAGLE Installation Manual page 77

Locate the jumper board on the Fuse and Alarm Panel (FAP).
1.
Unscrew the two thumbscrews securing the FAP jumper board and remove the board.
2.
On the jumper circuit board, unclip the 12-pin connector jumper from P72 and re-attach it
3.
to P71. Insert it until the plastic retaining clips "snap". See
jumper has a retaining strap so it will not get dropped or lost. This repositioning
establishes a connection between the diode boards with the input and fuse panels.
Figure 5-12
Slide the jumper board back into the FAP. Verify the OP/MAINT LED lights green. The
4.
fuse alarm LED returns to green.
The jumper board operational mode procedure is completed.
5.1.3.1.2 Operational Mode
Use this procedure to place the jumper board into operational mode. This mode of operation
allows one bus to pick up the entire load when there is a loss of input power on the other bus.
Procedure — Operational Mode
Locate the jumper board on the Fuse and Alarm Panel (FAP).
1.
Unscrew the two thumbscrews securing the FAP jumper board and remove the board.
2.
On the jumper circuit board, unclip the 12-pin connector jumper from P72 and re-attach it
3.
to P71. Insert it until the plastic retaining clips "snap". Note that the jumper has a retaining
strap so it will not get dropped or lost. This repositioning establishes a connection
between the diode boards with the input and fuse panels.
Figure 5-13
Slide the jumper board back into the FAP. Verify the OP/MAINT LED lights green. The
4.
fuse alarm LED returns to green.
The jumper board operational mode procedure is completed.
Jumper Connector - Operational Mode.
Jumper Connector - Operational Mode.
Chapter 5
Fuse and Alarm Panels
Figure 5-12. Note that the
5-11