Table of Contents
Advertisement
For the 10BASE-2 MAU, push the BNC connector on the coax cable onto the
f.
MAU and lock the connector in place by twisting the connector clockwise.
For a 10BASE-T MAU, push the RJ45 connector into the MAU until it snaps
into place.
Figure 6-6
Adapter Slide Latch
Tie-wrap each cable to the cable tie bar at the rear of the shelf and then to the
5.
cable tie bars at the side of the frame.
Pull the slack back toward the other end of the cables and lace to the cable rack.
6.
Ensure that each tie-wrap strap is cut flush with the tie-wrap heads so that no
7.
sharp edges are exposed.
Chapter 6
Intra-system Cable Installation
6-14
Advertisement
Table of Contents
