Table of Contents
Advertisement
6
Assemblies
6.1 Intra-system Cable Installation
This section covers the installation of cables that run within frames and between frames in a
multiple frame installation. The cables covered in this section have been connected at one
end in the factory and have connectors and are labeled at the other end for ease of
installation. Consult the Equipment Specification for this installation and the label at the
unconnected end of each cable to determine its connection point.
warning:
The intra-building port(s) of the equipment or subassembly is suitable for
connection to intra-building or unexposed wiring or cabling only. The intra-building
port(s) of the equipment or subassembly MUST NOT be metallically connected to
interfaces that connect to the Outside Plant (OSP) or its wiring. These interfaces
are designed for use as intra-building interfaces only (Type 2 or Type 4 ports as
described in GR-1089-CORE, Issue 4) and require isolation from the exposed OSP
cabling. The addition of Primary Protectors is not sufficient protection in order to
connect these interfaces metallically to OSP wiring.
The cables covered in this section are:
•
Interprocessor Message Transport (IMT) cables
•
Clock/Alarm cables
•
Interface cables
For additional information concerning cables and cable replacement, see
Adapters.
Recommended Tools
Oracle tools should be labeled "Property of ORACLE" with either a press-on Field Tool
Identification label or Field Tool Identification wrap.
•
Safety glasses
•
Tie-wrap tool
•
Flush cutters
•
Slotted screwdriver, 1/8-inch blade with 8-inch shank preferred
•
Phillips screwdrivers #2 and #3
•
Wrist strap
Cables and
6-1
Advertisement
Table of Contents
