Table of Contents
Advertisement
After the wires are attached correctly, the EAGLE terminal returns the following message:
tekelecstp 00-12-10 12:05:04 EST Rel 26.0.0
4277.0113
CLOCK SYSTEM
At the EAGLE terminal, reenter the clock status command to ensure that both primary
14.
and secondary BITS clocks are available again, enter:
rept-stat-clk
The output indicates whether the BITS clocks are running. In this example, the secondary
BITS clock is still active and the primary BITS clock is running but in standby mode.
tekelecstp 00-12-10 11:35:15 EST Rel 25.0.0-26.0.0
CARD LOC = 1114 (Active
PRIMARY BITS
= Idle
SECONDARY BITS
= Active
PSTSSTAST
SYSTEM CLOCKIS-NRActive-----
# Cards using CLK A = 11
# Cards using CLK B = 3
# Cards using CLK I = 0
PSTSSTAST
Command Completed.
Refer to
2
for output legend
Note:
There should be no bad clocks present in the output of the rept-stat-clk
command. If bad clocks are present, contact the
assistance.
Verify that you don't have any new alarms, refer to the recorded output obtained in 1. If
15.
you check the system for clock alarms, the output should show no clock errors; enter:
rept-stat-trbl
Note:
There should be no clock error messages present in the output of the rept-stat-
trbl command. If clock error messages are present, contact the
Support (MOS)
To continue this procedure to add the secondary HS clock cables go to 13.
16.
Clock alarm(s) cleared
) CARD LOC = 1116 (Standby)
PRIMARY BITS
SECONDARY BITS
# Cards with bad CLK A = 0
# Cards with bad CLK B = 0
for assistance.
= Idle
= Active
My Oracle Support (MOS)
My Oracle
Chapter 6
Source Timing
for
6-79
Advertisement
Table of Contents
