Place the new MCPM (E5-MCPM-B) card into its place.
b.
Be sure the revision numbers of the card is compatible with the EAGLE
c.
software release.
•
If they are not, go to
EAGLE system.
•
If your card is compatible with the EAGLE software relelease level, go to
7.
•
If in doubt about the compatibility of your new hardware, call the
Oracle Support
Enter the following command to flash the card:
5.
init-flash:loc=xxxx:code=appr
where xxxx is the location of the card.
The following is sample output.
rlghncxa03w 01-03-02 13:05:05 EST Rel 44.0
FLASH Memory Downloading for card 1105 Started.
rlghncxa03w 01-03-02 13:05:05 EST Rel 44.0
BLMCAP Downloading for card 1105 Complete.
rlghncxa03w 01-03-02 13:05:05 EST Rel 44.0
Command Completed.
;
Enter the following command to activate the FLASHGPL on the card:
6.
act-flash:loc=xxxx
where xxxx is the location of the card.
The following is sample output:
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 44.0
FLASH Memory Activation for card 1105 Started.
;
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 44.0
FLASH Memory Activation for card 1105 Completed.
;
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 44.0
Command Completed.
;
Enter the following command to return the upgraded MCPM card into service.
7.
alw-card:loc=xxxx
where xxxx is the MCPM card location.
•
This causes the MASP to begin downloading tables to the new MCPM card.
•
When the card has been successfully loaded there will be a response on the
terminal that downloading is complete.
•
This can take up to 10 minutes.
Enter the following command to verify the card is operational (IS-NR).
8.
5
to flash the card to the software release level of the
(MOS).
Chapter 6
User Upgrade Procedures
My
6-20