Table of Contents
Advertisement
rlghncxa03w 04-02-04 13:05:05 EST EAGLE 44.0
Command Completed.
;
Enter the following command to return the upgraded MCPM card into service.
22.
alw-card:loc=xxxx
where xxxx is the MCPM card location.
•
•
•
Enter the following command on the primary card to return the card to the status
23.
recorded in
init-card:loc=xxxx
where xxxx is the location of the primary card.
Enter the following command to verify the card is operational (IS-NR).
24.
rept-stat-meas
6.3.2 Measurement Collection and Polling Module (MCPM)
This procedure upgrades DSM cards loaded with the MCPM application (870-2371-03)
to EDSM cards with 32 MBFSRAM and 2 GBRAM loaded with the MCPM application
(870-2372-03).
Note:
DSM and EDSM cards loaded with the MCPM application will be referred to
as "MCPM cards."
The Primary MCPM card performs all measurements collection and reporting functions
and provides on-card RAM storage for collected data and scheduled reports. The
Secondary MCPM provides a redundant backup for the Primary module, and assumes
collection and reporting responsibilities on the loss of the Primary. TCP/IP connections
are used to deliver measurement reports from the Primary MCPM card to the
customer via an FTP client. The FTP configuration can be customized to support
automatic transfer of scheduled reports from the client to the server.
Enter the following command to determine the status and number of the MCPM
1.
cards.
rept-stat-meas
This causes the MASP to begin downloading tables to the new MCPM card.
When the card has been successfully loaded (there will be a response on the
terminal that downloading is complete.
This can take up to 10 minutes.
Note:
Ensure that the primary FTP server points to the primary card.
1
prior to the upgrade:
Chapter 6
User Upgrade Procedures
6-24
Advertisement
Table of Contents
