Table of Contents
Advertisement
Chapter 2
Components
warning:
Observe proper ESD procedures when handling the application server
chassis. Always wear an ESD wrist strap connected to a grounded bench or
frame.
warning:
Use the antistatic wrist strap connected to the wrist strap grounding point on
the frame when performing these procedures.
warning:
Do not leave or allow unused metal objects, such as screws or washers, to
remain anywhere within the equipment. Remove all unused material from the
equipment.
warning:
Do not allow any metal shavings to remain in the equipment area. Shavings
may occur from over tightened screws or bolts. These small metal particles
are hazardous to electronic equipment. Be careful not to over tighten screws
or bolts.
warning:
Do not use tie wraps on or above the top traverse arms on a frame. Always
trim tie wrap flush and turn the trimmed tie wrap to the rear of the cable.
Contact the Site Supervisor for site-specific customer information.
2.5 Components
warning:
If components arrive in containters that might have been subjected to
extreme temperatures or variations in humidity (such as air transport), allow
6 hours for the components to aclimatize to your site conditions before
operating.
2-6
Advertisement
Table of Contents
