Table of Contents
Advertisement
Install two square washers below the round fiberglass washer as shown in
3.
Install the anchor assemblies in the order shown in
4.
The large steel washer, nylon shoulder washer, and round fiberglass washer are found in
the mounting hardware kit.
Note:
When reassembling an anchor bolt assembly, lightly finger tighten only.
When reassembling an anchor stud assembly, the stud must be flush with the bottom of
the cone nut and the torque nut must be near the top of the stud.
Insert each anchor into an anchor hole through the three square washers, frame base,
5.
and isolation sheet (refer to
Figure 4-14
Anchor Installation of Heavy Duty Frame
Figure
Figure
4-14).
Chapter 4
Floor Preparation
Figure
4-13.
4-13.
4-17
Advertisement
Table of Contents
