Table of Contents
Advertisement
At the terminal, the EAGLE displays the following alarms:
tekelecstp 00-12-10 12:17:10 EST Rel 26.0.0
*
4306.0167
* CLOCK SYSTEM
tekelecstp 00-12-10 12:17:10 EST Rel 25.0.0-26.0.0
**
4307.0169 ** CLOCK SYSTEM
tekelecstp 00-12-10 12:05:04 EST Rel 25.0.0-26.0.0
*
4276.0161
* CLOCK SYSTEM
Legend: minor (*), major (**), critical (C*), and inhibited (I) alarms.
Caution:
If Both PRIMARY BITS and SECONDARY BITS clocks show FAULT condition,
reconnect the cable (P/N 830‑0226‑xx) to the appropriate connector (J48 or
J49) and abort this procedure. Contact the
assistance.
At the output panel of the customer composite clock source, locate the end of the
9.
composite/BITS clock cable (P/N 830‑0226‑xx) that was disconnected in
all wires.
Connect the new high‑speed source clock and composite cable (P/N 830‑0873‑xx or P/
10.
N 830‑1189‑xx) to the site HS clock source.
Cut the wires to length and strip.
a.
Wire‑wrap to the appropriate IDLE (primary or secondary) clock connections on the
b.
customer clock source. Refer to the cable wire coding (P/N 830‑0873‑xx or P/
N 830‑1189‑xx) shown in
•
Connect the HS clock source to the orange and white/orange wires.
•
Connect the composite clock source to the blue and white/blue wires.
1114-S clock failed
1114-S, 1116-S clocks failed
1116-S clock failed
My Oracle Support (MOS)
Figure 6-32
for connection information.
Chapter 6
Source Timing
for
8
and remove
6-65
Advertisement
Table of Contents
