Vism Card Prompt; Logging Out Of Vism And Pxm Cards - Cisco Voice Interworking Services (VISM) Installation And Configuration Manual

Chapter 4 Configuring VISM Features
1.17
1.18
1.19
1.20
1.21
1.22
1.25
1.26
1.27
1.28
1.29
1.30
1.31
1.32
NODENAME.1.7.PXM.a >
Step 8 Identify, from the list displayed in
Type the cc command (to change card), the VISM card slot number identified in
Step 9
The VISM card prompt is displayed. See the
information.
You have completed logging in to the PXM and VISM cards and can now perform the mandatory initial
VISM card configuration. Proceed to the

VISM Card Prompt

The VISM card prompt is displayed when you successfully log in to a VISM card and has the following
format:
NODENAME.1.9.VISM8.a
The VISM card prompt contains the following data:
•
•
•
•
•

Logging Out of VISM and PXM Cards

Enter one of the following commands to log out of the VISM and PXM cards:
•
•
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Empty
Empty
Empty
Empty
Boot VISM-8T1
Empty
Reserved VISM-8E1
Empty
Empty
Active VISM-8E1
Empty
Empty
Empty
Empty
Name of the MGX 8000 Series platform to which you are connected
Number of the shelf—always 1
Slot number
Card type
Card state—active (a) or standby (s)
bye
logout
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Clear
Step 7, the slot number of the VISM card you want to configure.
"VISM Card Prompt" section on page 4-5
"Initial VISM Configuration" section on page
Cisco VISM Installation and Configuration Guide
Connecting to Cisco MGX 8000 Series Platforms
Step 8, and press Enter.
for more
4-6.
4-5