Table of Contents
Advertisement
Chapter 5
CLI Commands
dspccs
To display the configuration data of a previously added common channel signaling (CCS) channel, use
the dspccs command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
operating modes.
Syntax Description
line-num
ds0-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configuration data of the CCS channel identified by line number
1 and DS0 number 10 are displayed:
dspccs 1 10
ds0IfIndex:
RowStatus:
LcnNum:
MaxFrameSize:
Related Commands
Command
addccs
delccs
dspccschans
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspccs line-num ds0-num
Line number of the previously added CCS channel in the range from 1 to 8.
DS0 number of the previously added CCS channel. It can be a value from one of the
following ranges:
1 to 24 for T1 lines
•
1 to 31 for E1 lines
•
10
active
36
300
Description
Adds a CCS channel (D channel) to a VISM card.
Deletes the association between a CCS (DS0) channel and its corresponding virtual
channel.
Displays all CCS configured channels.
Cisco VISM Installation and Configuration Guide
dspccs
5-319
Advertisement
Table of Contents
