Table of Contents
Advertisement
dsptoneplans
dsptoneplans
To display the tone configuration of all tone plans—either built-in (preconfigured) or provisional tone
plans—use the dsptoneplans command in the VoIP switching/trunking and switched AAL2 PVC
operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
This command displays the status of tone plans in the following ways:
•
•
•
Examples
The following example shows that the tone configuration for tone plans is displayed:
dsptoneplans
Status
---------
configure
configure
.
.
.
Related Commands
Command
addtoneplan
cnflnringback
cnflntoneplan
cnflntonetimeout
dellntoneplan
deltoneplan
dsplnringback
dsplntoneplan
Cisco VISM Installation and Configuration Guide
5-446
dsptoneplans
Configure—For a built-in (preconfigured) tone plan, and a provisional tone plan that is downloaded
properly and added to the system.
Lost File—For a provisional tone plan that is not downloaded properly or for a tone plan that is not
the proper one.
Reloading—For a provisional tone plan that is currently downloading.
Tone Plan Region
----------------
singapore
ITU
Description
Adds a tone plan to the current VISM card.
Configures the ringback tone method for a specified line on the current VISM
card.
Assigns a tone plan to a specified VISM card line.
Modifies the timeout periods of all call progress tones supported by VISM on
a specified VISM card line.
Deletes the tone plan configuration of a specified VISM card line.
Deletes a previously added tone plan from the current VISM card.
Displays the ringback tone method for a specified line on the current VISM
card.
Displays the tone plan configuration of a specified VISM card line.
Version
Tone Plan File Name
-------
-------------------
11
sing_3
1
BUILTIN
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
CLI Commands
Advertisement
Table of Contents
