Table of Contents
Advertisement
Chapter 5
CLI Commands
dsprtpcnt
To display the bearer counters (statistics) for a specific Real-Time Transport Protocol (RTP) VoIP
trunking connection, use the dsprtpcnt command in the VoIP switching/trunking and VoIP and switched
ATM AAL1 SVC operating modes.
Syntax Description
conn-num
Command Modes
VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the bearer counters (statistics) for the static RTP connection number
132 are displayed:
dsprtpcnt 132
Connection Index :132
Packets Sent
Packets Received :0
Octets Sent
Octets Received
Packets Lost
Related Commands
Command
addlapdtrunk
addrtpcon
addrudptrunk
clrrtpcnt
cnflapdtrunkpvc
cnflntrunkcond
cnfrtpcon
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI backhaul RUDP
dellapdtrunk
delrtpcon
delrudptrunk
dsplapd
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsprtpcnt conn-num
Connection identification number. It can be in the range from 1 to 248.
:99604
:7966804
:0
:0
Description
Adds an LAPD trunk to a specific VISM card line.
Adds a static RTP VoIP trunking connection.
Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
Clears the RTP counters (statistics) for a specific static RTP connection.
Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.
Modifies an existing static RTP VoIP trunking connection.
trunk for a specified session.
Deletes an LAPD configured line.
Deletes a static RTP VoIP trunking connection.
Deletes an ISDN PRI backhaul RUDP session that is associated with an LAPD.
Displays data about an LAPD.
Cisco VISM Installation and Configuration Guide
dsprtpcnt
5-407
Advertisement
Table of Contents
