Table of Contents
Advertisement
cnfsesport
cnfsesport
To configure the port numbers of a previously added PRI backhaul session, use the cnfsesport command
in the VoIP switching/trunking operating mode.
Syntax Description
session-num
local-port-num
remote-port-num
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that session number 4 is configured with local (VISM) port number 1200
and remote (call agent) port number 1204:
cnfsesport 4 1200 1204
Related Commands
Command
cnfsesack
cnfsesmaxreset
cnfsesmaxseg
cnfsesnullsegtmout
cnfsesoutofseq
cnfsesretrans
cnfsesstatetmout
cnfsessyncatmps
Cisco VISM Installation and Configuration Guide
5-210
cnfsesport session-num local-port-num remote-port-num
Identifying session number in the range from 1 to 64.
Local port number. The VISM port number used for the session. It can be in
the range from 1124 to 65535.
Remote port number. The call agent port number used for the session. It can
be in the range from 1124 to 65535.
Description
Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
Configures the maximum number of resets that a VISM card performs before
a connection is reset.
Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
Configures the idle time before sending a null segment.
Configures the maximum number of out-of-sequence packets that can be
accumulated before sending an EACK packet.
Configures the timeout period for unacknowledged packets and the number
of retransmissions.
Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
Configures the maximum number of call agent synchronization attempts.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
