Table of Contents
Advertisement
Chapter 5
CLI Commands
dsplapd
To display configuration data about a Link Access Protocol D channel (LAPD), use the dsplapd
command in the VoIP switching/trunking operating mode.
Syntax Description
line-num
ds0-num
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the LAPD configuration data is displayed for line number 1, DS0
number 1:
dsplapd 1 1
vismRudpSessionStatNum:
vismRudpSessionAutoResets:
vismRudpSessionRcvdAutoResets:
vismRudpSessionRcvdInSeqs:
vismRudpSessionRcvdOutSeqs:
vismRudpSessionSentPackets:
vismRudpSessionRcvdPackets:
vismRudpSessionSentBytes:
vismRudpSessionRcvdBytes:
vismRudpSessionDataSentPkts:
vismRudpSessionDataRcvdPkts:
vismRudpSessionDiscardPkts:
Trunk type:
Related Commands
Command
addlapd
addlapdtrunk
addrtpcon
addrudptrunk
clrrtpcnt
cnflapdtrunkpvc
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsplapd line-num ds0-num
Line number of the channel for which you want to display the LAPD
configuration data. It can be in the range from 1 to 8.
DS0 number of the channel for which you want to display the LAPD
configuration data. It can be a value from one of the following ranges:
1 to 24 for T1 lines
•
1 to 31 for E1 lines
•
Description
Adds an LAPD.
Adds an LAPD trunk to a specific VISM card line.
Adds a static RTP VoIP trunking connection.
Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
Clears the RTP counters (statistics) for a specific static RTP connection.
Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
1
0
0
0
0
5
0
0
0
0
0
0
Backhaul
Cisco VISM Installation and Configuration Guide
dsplapd
5-351
Advertisement
Table of Contents
