Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 424

dspaal2params
dspaal2params
To display AAL2 configuration parameters, use the dspaal2params command in the switched AAL2
PVC and AAL2 trunking operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes Switched AAL2 PVC and AAL2 trunking
Usage Guidelines
Use this command to display the following AAL2 configuration parameters:
•
•
•
•
•
Examples
The following example shows that the AAL2 configuration parameters are displayed:
dspaal2params
AAL2 DTMF RELAY:
AAL2 CAS BITS TRANSPORT:
AAL2 TYPE3 REDUNDANCY:
AAL2 VAD TIMER:
AAL2 CID FILL TIMER:
Related Commands Command
cnfaal2timerparams
cnfaal2transparams
Cisco VISM Installation and Configuration Guide
5-280
dspaal2params
DTMF relay status
CAS bit transport status
Type3 redundancy status
VAD timer value
CID fill timer value
Off
Off
On
250
30
Description
Configures the holdover time for VAD before activating silence suppression
on an AAL2 PVC.
Configures the transportation of DTMF and CAS bits to another endpoint
and enables or disables the type 3 packet triple redundancy feature.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands