Table of Contents
Advertisement
addmgcgrpprotocol
resp-ack
disc-proc-enable
cancel-grace
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
This command allows you to add multiple protocols to the same redundancy group.
Examples
The following example shows that call agent redundancy group number 3 is assigned gateway control
protocol number 2, SGCP 1.1+:
addmgcgrpprotocol 3 2
Related Commands
Command
addmgcgrpentry
cnfdisctimers
cnfmgcgrpentry
cnfmgcgrpparam
cnfmgcgrpprotocol
cnfsrcppeer
cnfsrcppeergrpparam
delmgcgrpentry
delmgcgrpprotocol
dspdisctimers
Cisco VISM Installation and Configuration Guide
5-32
(Optional) Enables or disables sending a response acknowledgment. It can
be one of the following values:
•
1 = On (Default for MGCP 1.0)
•
2 = Off (Default for MGCP 0.1, SGCP 1.1+, SRCP 1.0.2, and SGCP 1.5)
(Optional) Enables or disables the disconnect method, which indicates that
the endpoint has become disconnected and is now trying to establish
connectivity. It can be one of the following values:
•
1 = On (Default for MGCP 1.0)
•
2 = Off (Default for MGCP 0.1, SGCP 1.1+, SRCP 1.0.2, and SGCP 1.5)
(Optional) Enables or disables VISM cancelling a previously issued graceful
restart in progress command. It can be one of the following values:
1 = On (Default for MGCP 1.0)
•
2 = Off (Default for MGCP 0.1, SGCP 1.1+, SRCP 1.0.2, and SGCP 1.5)
•
Description
Configures call agents as part of an MGC redundancy group and assigns a
priority value for a call agent.
Specifies the wait delay times for the disconnected procedure, restart in
progress command—initial, minimum, and maximum timer values.
Modifies the call agent priority level of a call agent within a call agent
redundancy group.
Modifies a call agent redundancy group state change notification policy and
priority level.
Configures call agent group protocol data.
Configures the SRCP parameters when SRCP is the selected protocol for
communication between the VISM card and call agent.
Modifies the SRCP heartbeat interval and maximum UDP size for a
specified call agent redundancy group.
Deletes a call agent from a call agent redundancy group.
Deletes an MGCP from a specified call agent redundancy group.
Displays the Restart in Progress command disconnect type method wait
delay times.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
